Filter
Top Products
axxessinterface.com 800.221.0932
10
10) After 4 seconds of the led ashing quickly the led will go out for 2 seconds.
11) Then the led will ash, up to 9 times, depending on what radio the ASWC thinks it’s connected to.
Here are the led blinks and which radio they represent:
1st led ash is for Eclipse
2nd led ash is for Kenwood
3rd led ash is for Clarion
4th led ash is for Sony and Dual
5th led ash is for JVC
6th led ash is for Pioneer and Jensen
7th led ash is for Alpine*
8th led ash is for Visteon
9th led ash is for Valor
* Note: If the ASWC ashes 7 times and you do not have an Alpine radio connected to it that means
that the ASWC did not see any radio connected. Verify the 3.5mm connector is connected to the
SWC input on the radio.
12) Make sure the number of ashes match what radio you have installed.
13) If the led ashes match the radio then hold down the Volume Down button until the led goes solid
red.
14) Programming for the vehicle and the radio is now complete. Test out the steering wheel control
functions to make sure it works correctly.
If the led ashes do not match the radio you have connected, you must manually program the ASWC
to tell it what radio it is connected to.
1) To manually program the aftermarket radio, press and hold the Volume Up button on the steering
wheel control until the led goes solid red, then release Volume Up.
2) At this point Eclipse is programmed.
If you are using an Eclipse radio go to step 3.
If you are using a different radio go to step 4.
3) Press and hold Volume Down for 5 seconds. The led will ash once then go solid red indicating the
programming has nished. Go enjoy your radio.