Filter
Top Products
axxessinterface.com 800.221.0932
6
* If the ASWC was installed in a vehicle before:
2) Turn the ignition on, the led will ash slowly
3) Hold down the reset button for more then 2 seconds but less then 10 seconds, the led will start
ashing rapidly
4) Perform action required for your particular vehicle as noted in the vehicle info sheet
5) After a couple of seconds the led should stop ashing and not light up for 2 seconds. At this point
do not push any buttons.
6) After the 2 seconds there will be a series of 7 ashes, some short and some long.
7) The led will pause another 2 seconds then a series of 9 ashes.
8) This is the end of the auto detection stage. If the ASWC detected the vehicle and the radio
successfully the led will light up solid red.
9) Make sure the steering wheel control buttons function correctly in the vehicle and enjoy your radio.
So what if the led does not light up solid red or the steering wheel controls is not working correctly
with the aftermarket radio?
Check out troubleshooting section right below.
Troubleshooting the Auto Detect Mode
So you tried the auto detect feature and at the end the led did not stay on solid red, it started ashing.
That means the ASWC did not detect the vehicle. Follow these couple steps to determine what hap-
pened:
First some basic steps:
1) Verify that you have 12 volt accessory and a good ground to the ASWC.
2) Verify with the vehicle information sheet on the Axxess website that you connected the correct
steering wheel control wires in the vehicle to the correct wire(s) on the ASWC.
3) Verify that the 3.5mm connector is connected to your radio securely and in the correct location.
4) If using the female 3.5mm connector on an Eclipse or Kenwood radio, verify that the radio’s SWC
wire is connected to the correct wire on the ASWC.