Filter
Top Products
axxessinterface.com 800.221.0932
5
For the Auto Detect feature to work there are 3 possible actions, however only one action will be re-
quired by you depending on your vehicle:
1) Turn the ignition on and no other action is required.
2) Turn the ignition on, press and hold down the Volume Up button on the steering wheel.
Or
3) Turn the ignition on, press and release the Volume Up button repeatedly on the steering
wheel.
Like we said before, only one of these actions will need to be done depending on your vehicle for the
auto detect feature to work. Please refer to the vehicle info sheet in the Axxess website.
These are the steps for the Auto Detect Mode:
1) Complete connections to the vehicle and the aftermarket radio.
* If this is the rst time the ASWC is being installed in a vehicle:
2) Turn the ignition on; the led will start ashing rapidly which means the ASWC is looking for the
vehicle and the radio.
3) Perform action required for your particular vehicle as noted in the vehicle info sheet.
4) After a couple of seconds the led should stop ashing and not light up for 2 seconds. At this point
do not push any buttons.
5) After the 2 seconds there will be a series of 7 ashes, some short and some long. Make a note of
which ashes were long for this may be needed later.
6) The led will pause for another 2 seconds then ash up to 9 times. Again make a note of how many
ashes.
7) This is the end of the auto detection stage. If the ASWC detected the vehicle and the radio
successfully the led will light up solid red.
8) Make sure the steering wheel control buttons function correctly in the vehicle and enjoy your radio.
So what if the led does not light up solid red? Check out troubleshooting section below.