Filter
Top Products
21
© 2005 directed electronics—all rights reserved
valet take-over
The Valet Take-Over feature allows the vehicle to remain running
after the key has been removed from the ignition. This feature is
useful for occasions when you wish to exit and lock the vehicle
for short periods of time, but would like to leave the motor
running and the climate controls on.
To perform Valet Take-Over:
1. Before turning off the engine, press and release twice
within 3 seconds on the transmitter (or press and release the
optional momentary switch). Then wait five seconds.
2. Turn the ignition key to the OFF position. (The engine will
stay running.)
3. The engine will run until the pre-programmed time elapses
or a shut-down input is received. (See the previous
Remote
Start
section for a complete list of shut-down inputs.)
short-run/turbo
Short run turbo mode keeps the engine running after arriving at
you destination for a programmable period of 1, 3, 5 or 10
minutes. This allows the system’s timer to conveniently cool
down the turbo after you have left the vehicle.
➜
note: This feature will not work if the brake pedal is
being pressed.
➜