Avital 834002 Automobile Alarm User Manual


 
© 2005 Directed Electronics, Inc. Vista, CA
3399
Pressing a fourth time within five seconds: The siren chirps four times followed by a long chirp.
Zones Two and Four are now bypassed.
Pressing a fifth time within five seconds: The siren chirps five times followed by a long chirp. All
input zones, except the ignition, are now bypassed.
ssyysstteemm ffeeaattuurreess lleeaarrnn rroouuttiinnee
The System Features Learn Routine™ dictates how the unit operates. Due to the number of features, the
features have been divided into three menus. It is possible to access and change any of the feature set-
tings using the Valet®/Program switch. However, this process can be greatly simplified by using the Bitwriter™.
Any of the settings can be changed and then assigned to one of up to four transmitters, a feature called Owner
Recognition. Each time that particular transmitter is used to disarm the system, the assigned feature settings
will be recalled. Owner Recognition is only possible when programming the unit via the Bitwriter.
The learn routine may be locked if previously programmed using the Bitwriter. If the horn generates one
long honk when attempting to program the unit, the learn routine is locked and must be unlocked using
the Bitwriter™ before proceeding.
TToo pprrooggrraamm tthhee ffeeaattuurreess uussiinngg tthhee VVaalleett sswwiittcchh::
1.
OOppeenn aa ddoooorr..
(The GREEN wire, H1/5, or the VIOLET, H1/7 must be connected.)
2.
KKeeyy..
Turn the ignition on and then back off.
3.
SSeelleecctt MMeennuu..
Press and
HHOOLLDD
the Valet®/Program switch. When the LED flashes once and
the siren chirps, Menu One has been selected. Continue to hold the switch until the LED
flashes twice and the siren chirps twice, Menu Two has now been selected. Continue to
hold the switch until the LED flashes three times and the siren chirps three times, Menu
Three has now been selected. Release the switch after the Menu choice has been selected.
4.
C
Chhoooossee..
Within 10 seconds, press and release the Valet®/Program switch the number of
times corresponding to the feature number you want to program and then press and hold
the switch. (See
Feature Menus
.)
After a second, the LED will flash to indicate which feature you have accessed. For example, in Menu Two, groups
of eight flashes would indicate access to the activation pulse setting (Feature 2-8). The horn will also honk eight
times (if connected).