Filter
Top Products
PASSIVE CAR JACK:
Operates as below:
1. Turn the ignition switch “ON”, Car-Jacking will arm.
2. Once the system is armed, if you are forced from the vehicle, the system will trigger when the
door is opened and closed while the ignition is “ON”.
TRIGGER THE CAR JACK MODE:
3-timer circuits will function as follows:
First timer:
a. 50 seconds after the system has beer triggered. The siren will start chirping for 15
seconds.
b. During this 15 seconds period of chirping, you will be alerted to turn off the car-jacking
feature.
c. If not, it will enter the second timer car jacking.
Second timer:
65 seconds after the system has beer triggered. The siren starts alarming and the parking
light starts flashing.
Third timer:
90 seconds after the system has been triggered
a. The siren still alarming and the parking light flashing, and
b. The starter disable will activate to prevent the vehicle from starting.
c. It will remain active until the vehicle's battery power exhausted.
OVERRIDE THE SYSTEM TO TURN OFF CAR JACKING:
Turn the ignition switch from OFF to ON, and within 10 seconds push valet switch, the siren
will stop and the system disarmed
Note: If you use password pin code to double protect the vehicle security, you will need to use
it to completely disarm the system.
DOME LIGHT CONVENIENCE DELAY & SUPERVISION
The alarm has a unique feature which will turn on your vehicle dome light as following:
1. Upon disarming, the interior lights will remain on for 30 seconds.
2. If the vehicle is intruded, the interior light will flash for the same duration as the siren.
Note: Turn on the ignition switch on or arm the alarm will turn off the dome light.
IGNITION CONTROL DOOR LOCKS.
(See Alarm Feature II – 2 Programming).
If the vehicles door locks have been interfaced to the security system, the system will
automatically lock the vehicle's doors when the ignition is turned “ON” and /or unlock the
vehicle’s doors when the ignition is turned “OFF”.
TRUNK RELEASE.
(See Alarm Feature II – 6 Programming.)
Press and hold the
button on transmitter for two seconds to remote control the trunk
release or other electric devices.
SYSTEM’S STATUS CHECK.
When you want to check the system’s present status thru the LCD screen, Press the
button on “Two Way LCD Screen Transmitter”, With one melody sound, the system’s status
will be shown on the LCD screen.
Note: Press for 2 seconds with 2 beeps confirmation to clear the trigger icons of LCD
screen.