Filter
Top Products
TO OPERATE THE VEHICLE WHILE RUNNING ON THE REMOTE START:
1. Insert the ignition key and turn it to “ON” (not the start) position.
2. Press the brake pedal.
Note: If the brake pedal is pressed before the key is in the ON position, the engine will shut
down.
TEMPORARY STOP FEATURE:
This feature allows the vehicle to remain running after the key has been removed from the
ignition. This feature is useful for occasions when you wish to exit and lock the vehicle for short
periods of time, but would like to leave the motor running and the climate control on.
1. Before turning off the engine, press the
button on the transmitter and the LED indicator will
flash 3 times to confirm enter.
2. Turn the ignition key to OFF position. (The engine will stay running.)
3. The engine will run until the pre-programmed time elapsed or shutdown input is received.
TIMER / TEMPERATURE START:
This unit can be programmed to start and run the engine every 3 or 24 hours. The engine will
run for the programmed run time and then shut down.
IMPORTANT: Timer Start should be used only in open areas, Never start and run the vehicle in
on enclosed space as a garage or carport.
3 hours timer start with Temperature-control OFF: This feature is design for an extreme cold
climate usage. The system will auto start the vehicle every 3 hours, to prevent engine freezing
and hard to start. A MAXIMUM OF SIX CYCLES CAN OCCUR.
3 hours timer start with Temperature-control: If you installed the optional Temperature
Sensor and programmed the temperature ON to operate. The system can be programmed to
automatically start the vehicle engine whenever the temperature inside the vehicle reaches or
drops below the preprogrammed temperature level. The system will monitor the air temperature
every 3 hour and will only start the engine during extreme cold temperatures. There are three-
temperature levels to choose form. This feature is programmed OFF from the factory and must
be programmed ON to operate. (See Start Feature I – 7 Programming)
24 hours timer start: This feature is design for a battery charge usage. When the car owner is
on a long vocation, he can use this feature to auto start the vehicle and charge the battery every
day, to prevent a low battery.
ENTER:
1. Press the
button to remote start the vehicle. As soon as the vehicle is running and the
parking light have turned on.
2. Immediately depress the
button once, within 2 seconds.
3-a. 3 Hours auto start: Rapidly depress the
button once. The parking light will flash (3) times.
The siren or horn chirps (3) times. The vehicle is now programmed to start every (3) hours.
3-b. 24 Hours auto start: Rapidly press and hold the
button once. The parking light will flash (12) times. The siren
or horn chirps (12) times. The vehicle is now programmed to
start every (24) hours
4. Press the brake pedal to stop the vehicle running.
Exit the timer start:
Timer start can be exited manually as follows:
1. Make sure the remote start system is not operating the engine.
2. Turn the ignition on. The parking light will flash (4) times. The horn chirps (4) times.
Or
1. Press the
button to remote start the vehicle. As soon as the vehicle is running and the
parking light have turned on or flashing.
2. Immediately depress the
button then press and hold the
button for 2 seconds. The
parking light will flash (4) times. The siren or horn chirps (4) times. The vehicle is no longer
programmed to start automatically.