Filter
Top Products
TRIGGER THE SYSTEM
When armed, your vehicle is protected as follows:
1. Light impacts will trigger the warn-away signal. A [3] long chirp from siren/horn.
2. Heavy impacts / Doors open / Hood open / Trunk open / Turn on the ignition key/
Activate PIR sensor / Activate door/window sensor will trigger the programmed sequence.
The starter disable relay (if installed) prevents the vehicle’s starter from cranking. The siren,
horn, parking lights, and dome light will turn on alerting of an intrusion for 60 seconds. Then it
will stop and automatic reset and re-arm. If one of the sensors or detectors is still active, the
alarm system will sound a maximum of 3 times of 60 seconds cycles.
Doors Trigger Trunk/Hood Trigger
Optional Sensor Trigger Ignition Trigger Activate PIR Sensor
NOISE ABATEMENT CIRCUIT: You system has “Noise Abatement Circuit”. It prevents
annoying repetitive trigger sequences due to faulty door pin switches or environmental condition
such as thunder, jackhammers airport noise, etc.
Here’s how “Noise Abatement Circuit” works: The alarm triggers five times. Each time, the same
sensor or switch is triggering the alarm. “Noise Abatement Circuit” will interpret this pattern of
triggers as false alarm. After the fifth trigger, “Noise Abatement Circuit” ignores, or bypasses,
that sensor or switch until another sensor or switch is triggered.
Doors, Hood & Trunk are covered by “Noise Abatement Circuit” differently: If the alarm is
triggered by an open door for six full cycles (1 ½ minutes), the doors will be bypassed until the
trigger ceases.
ANTI CAR-JACKING
Warning: If you don't need the car jacking function in this alarm system, be sure to set
car jacking feature “OFF”. This system is default setting with all car-jacking “OFF”.
(See Alarm Feature I - 5 Programming.)
ACTIVE CAR JACK:
1.
Press and hold
button on the transmitter for 2 seconds
while the vehicle’s ignition is ON. The parking lights will
turn on for 1.5” seconds to indicate Car-Jack “on”.
2.
Once the system is armed, if you are forced from the
veh
icle. The system will trigger when the door is opened
and closed while the ignition is “ON”.
Note: The LCD will display a icon when car-jacking is active.