Filter
Top Products
EXAMPLE: To Override The System With The Password Code 51, you would;
1. Enter the vehicle and turn the ignition switch to 'ON’ position. (Alarm will sound.)
2. Within 5 seconds, Press and Release the Valet Switch 5 times
(When finished above procedures, the system's siren will stop; parking light will stop
flashing and all sensors will stop triggering but the vehicle cannot be started.)
3. Within 15 seconds of the first digit entered, turn the Ignition Switch “OFF” then “ON”.
4. Within 15 seconds, Press and Release the Valet Switch 1 time.
5. Turn the Ignition Switch to “Off” position.
[2] Chirps form siren/horn, [2] flashes from parking lights and LED will turn off to indicate the
system was disarmed.
VALET MODE: (Manual Disarm or Valet mode)
The valet switch allows you to temporarily bypass all alarm functions, eliminating the need to
hand your transmitter to parking attendants or garage mechanics. When the system is in the
valet mode, all alarm functions and remote start functions are bypassed. However the remote
panic feature and remote keyless entry will remain operational. To use the valet mode, the
system must first be disarmed either by using you remote transmitter, or by operating the
Manual override sequence.
Enter Valet Mode:
1.
From the disarmed condition, turn the
ignition to “ON” position.
2.
Push and hold valet switch for 2
seconds until the LED turn on. The
LED will remain on as long
as the
system is in 'valet mode'.
Note: The LCD transmitter will sh
ow Z’s on
the display to indicate in the Valet mode.
Remote Door Lock
Remote Door Unlock
Exit Valet Mode:
1. Return to normal operation, turn ignition 'on'.
2. Push and hold valet switch for 2 seconds, The LED will turn off indicating the system is
exiting the valet mode.
CAR LOCATOR
Press the
button to active car locator function. The siren will chirp 6 times. The parking light
will flash 12 times, for you to easily locate your car.
PANIC FUNCTION: (See Alarm Feature I – 7 Programming)
The transmitter can be used as a remote panic switch to manually trigger the alarm in case of
an emergency.
1. Press and hold the
button for 3 seconds. The alarm will immediately sound.
2. During panic mode, the normal functions of this transmitter button will be suspended. The
and
buttons can be used to lock and unlock the doors (if the option is installed),
however once the
button is pressed, the vehicle’s starter disable device,
(if the option is installed), will activate, not allowing the vehicle to start.
3. To stop the alarm panic, press and hold the
or
or
or
button on the transmitter
for 3 seconds. Also if any transmitter button other than the
or
or
or
button is
pressed and released, the panic mode will be turned off immediately.
4. If no buttons are pressed, the alarm will automatically stop after 60 seconds.