Filter
Top Products
PRE-INSTALLATION NOTES:
Installation Manual
Page 1
®
AUTO LOCK / UNLOCK: DIP SWITCH #1
The system is shipped with this feature activated.
Any time the ignition key is turned to the off position, the doors will automatically unlock. Any time the ignition key is turned
to the on position, the doors will automatically lock.
To disable the auto lock / unlock feature, move dip switch number 1 to the “off” position.
PASSIVE / ACTIVE DOOR LOCK SELECTION: DIP SWITCH #2
This feature will only affect the operation of the system if the passive arming feature is selected.
When active door lock is selected, the doors will only lock when the transmitter button is pressed. When the alarm is allowed to
arm passively, at the end of the 30 second arming cycle, the doors will not automatically lock. The system is shipped in the active
door lock mode, therefore, no modifications are required for this feature.
When passive door lock is selected, and the alarm is allowed to arm passively, at the end of the 30 second arming cycle, the doors
will automatically lock. To program this feature, move dip switch number 2 to the on position.
This alarm can be wired to operate as a Voltage Sensing or a Hardwire system.
As a voltage sensing system, the alarm will trigger any time an entry point that illuminates a courtesy light is opened. The system is
shipped in the voltage sensing mode, therefore, no modifications are required to make this system a voltage sensing alarm.
As ahardwire system,the alarmwill triggerany timea door,hood, trunk,etc. isopened, bywiring directlyto theswitches. Thismeans
that ifthe courtesylight isburned out,or thecourtesy lightfuse isblown, thealarm willcontinue toprotect allpoints ofentry. Tomake
this system operate as a hardwire alarm, move dip switch number 4 to the off position.
NOTE: When “Passive Arming” and “Voltage Sensing” are selected, you must hardwire the driver’s door pin switch or passive
arming will never be initiated.
CHANNEL 2 OUTPUT:
This system provides an on board 10 A relay to activate the factory installed trunk release solenoid.
VOLTAGE SENSE / HARDWIRE SELECTION: DIP SWITCH #4
PASSIVE / ACTIVE ARMING SELECTION: DIP SWITCH #3
This alarm can be programmed to operate as either a “PASSIVE” or “ACTIVE” arming security system.
As a “Passive” alarm, the system will automatically arm itself approximately 30 seconds after the ignition key is turned off, one
door is opened,then allvehicle doors areclosed, (arming issuspended until thelast door isclosed). This featureprotects the vehicle
in the event you forget to arm the system using the keychain transmitter. When the optional door lock interface is installed, the
doors will operate according to the position of dip switch number 2.
This system is shipped in the passive mode, therefore no modifications are required to make the system operate as a “Passive”
alarm.
As an “Active” alarm, the system can only be armed using the keychain transmitter. There will be no backup automatic arming.
To make the system operate as an “Active” alarm, move dip switch number 3 to the off position.
Model PS-330i