Filter
Top Products
REMOTE START SELECTABLE FEATURES
RF Programmable Features:
Feature Selection Park Lights Flash 1 x Park Lights Flashes 2 x Default LED Pattern
First RF start chirp confirm off RF start chirp confirm on Off 1 x Pause etc.
Second 10 minute run time 15 minute run time 10 Minutes 2 x Pause etc.
Third Parking lights on steady Parking lights flash Steady 3 x Pause etc.
Fourth (No function) Tach operation Tach 4 x Pause etc.
Fifth (No function) (No function) ---------------- 5 x Pause etc.
Sixth Ignition 2 off during crank Ignition 2 on during crank Off during crank 6 x Pause etc.
Seventh Diagnostics off Diagnostics on Off 7 x Pause etc.
Eighth (No function) (No function) ---------------- 8 x Pause etc.
To Program The Remote Start Selectable Features:
1. Start with the valet/program switch in the "Off" position.
2. Turn the ignition key to the On position.
3. Flip the valet/program switch On, Off, On, Off, On, then Off.
4. Immediately turn the ignition key Off then press transmitter button 2 for 1 second.
5. Immediately turn the ignition key back On.
6. Flip the valet/program switch On, Off, On, then Off. The siren will emit 2 short and 1 long chirp
verifying you are in the feature program mode.
7. Use button 1 on the transmitter to advance to the feature you want to change.
EXAMPLE
- If you
need to change selectable feature 3, press and release button 1 three times in succession. The
parking lights will flash, and the siren will chirp 3 times confirming that selected feature 3 can be
changed.
8. Use button 2 on the transmitter to change the selection of the programmable feature. If you are not
sure what the setting for any feature is, press button 1, one time, the parking lights will flash once or
twice indicating the features setting.
NOTE: Once you've entered the program mode DO NOT allow more than 15 seconds to pass between
steps, or the programming mode will be terminated.
Programming Tach Rate:
The AA-RS20CS will learn the tach rate of the vehicle. To learn tach.
1. Start with the programming switch in the Off position.
2. Turn the ignition key to the On position.
3. Flip the valet/program switch On, Off, On, Off, On, then Off.
4. Immediately turn the ignition key Off.
5. Flip the valet/program switch On, then start the vehicle using the key.
6. When the unit senses the tach signal, the parking lights will begin to flash.
7. Flip the valet/program switch Off, The parking lights will turn on for three seconds to indicate that the
learned tach signal is stored and the unit is out of the tach learn mode.
NOTE: If the unit fails to learn tach rate due to an improper tachometer connection or a poor tach
source, the unit will go into a fail-safe mode. While in this mode, the remote start transmitter will
not function and the program switch will stop responding. This will be indicated by the LED
turning on and off with each operation of the program switch. To correct this situation, locate and
connect the Green/Orange wire to the proper tach signal, disconnect the power wire to the
control module, repower the circuit, re-enter and learn the proper tach signal.
Diagnostics:
Enter selectable feature #7 and turn on as described above.
NOTE: Diagnostic mode is a temporary mode. Once you have accessed the diagnostic mode, the unit
16