Filter
Top Products
Brake Switch Positive Shutdown Detail
Starter Inhibit Wiring Detail
10
Black
White/Black
Remote Start to shut down if an attempt is made to operate the vehicle without the key while running
under the control of the Remote Start. In most vehicles, in order to shift into gear, the brake pedal must
be depressed. The brake input will in turn cause the remote start unit to shut off. See detail in the
following diagram for wiring the brake light circuit.
Black Wire: Chassis Ground Source
Connect the Black wire to a known vehicle ground source or to a solid clean metal part of the chassis.
Be certain to remove any paint or grease and secure this wire with a self taping screw and ring terminal.
Green w/ Orange Trace Wire: Tachometer Input Signal
This wire will continually monitor the engine tach rate while the unit is under power of the Remote Start
module. This wire will be routed to the vehicle ECM tach input or through the firewall into the engine
compartment and connect to the negative side of the ignition coil. This Remote Start unit learns the
tach rate of the vehicle and in most cases will operate properly from one multi coil pack regardless of
the number of cylinders. If the vehicle has a single coil unit for each cylinder, it may be necessary to
connect this wire to more than one cylinder for proper tach reference. See multi coil wiring detail shown
later in this manual for additional information.