Filter
Top Products
128-7853
15 of 16
15
3. Within 10 seconds of the key turning off, cycle the enable switch Off, On, Off, On ( 2 times) to
select a 2 hour timed start interval. Cycle the enable switch Off, On, Off, On, Off, On, Off, On (4
times) to select a 4 hour timed start interval. The lights will flash and the siren will chirp 2X or
4X dependant upon 2 or 4 hour interval setting.
NOTE: Once selected, 2 or 4, this timer interval will remain in memory until it is manually
changed. To change, the above sequence will have to be followed.
TIMED START OPERATION:
To begin the start timer, within 10 seconds of turning off the ignition switch, activate the RF
command to start 2 times. (Press the start button four times). The lights will flash and the siren
will chirp 4 times. Indicating timed interval mode has been initiated. The vehicle will automati-
cally start every 2 or 4 hours as programmed. To cancel the timed start mode start the vehicle
either by RF or by the ignition key.
COMPLETING THE INSTALLATION:
After you have confirmed the operation of the Audiovox Remote Start unit and tested all the safety
features of the system:
NOTE: This unit has the ability to learn the dome light delay time, up to 60 seconds. If the
vehicle has delay interior lights, and you wish to avoid three chirp, defect zone, indication
normally associated with this type of interior light, we suggest you learn the interior light
delay.
To learn the light delay, start with all doors closed:
(1) Use the transmitter to Lock / Unlock / Lock / Unlock / Lock / Unlock / Lock, the system. The
LED turns on solid to confirm the system entered the learn mode.
(2) Immediately open and close the door of the vehicle to initiate the dome delay. The unit will
monitor the door trigger input Positive, (Purple), and Negative, (Brown) when active. When
the dome light turns off, the unit will add 2 seconds then exit the learn mode.
(3) The LED will begin flashing the Armed indication indicating the unit has exited the learn
mode and is armed.
a. Mount the control module up and behind the dash securing it in place with cable
ties or screws. Be certain that the chosen mounting location will not inhibit any of the
controls of the vehicle.
b. Securely harness and tie all wiring up and away from all hot and moving parts that
they may come in contact with under the dash board or in the engine compartment
areas.
CAUTION: Particularly avoid the area around the steering shaft and column, as
wires can wrap around these mechanisms and impair the safe operation of the
vehicle.
c. Apply the Caution Labels supplied with this kit to a conspicuous area in the engine
compartment. Make sure to clean the surface before affixing the label.
d. Check the vehicle's wipers, lights, horn, etc.... to insure proper operation.
e. Replace all panels that were removed during installation, and retest the system.
f. Explain all activated features and safety systems associated with Remote Start Unit
installed to the customer.