Filter
Top Products
Navigating a Saved Track
When initiated, a TracBack route takes you back to
the oldest stored track log point.
To use the TracBack feature:
1. With the Saved Tracks Page for the track or
the Track Log open, highlight the TracBack
button, and press ENTER to open the
TracBack Page showing the entire track. You
are then prompted to select the point you want
to go back to.
2. Use the ROCKER to move the pointer to the
point on the map, and press ENTER to start
navigating the TracBack.
Directions
to the rst
turn
3. Select either Follow Road to route back to
the selected point using available roadways,
or select Follow Track to retrace your original
path of travel. Highlight the Don’t Ask Again
option, and press ENTER if you want to use
the same option each time you use TracBack.
The Map Page opens with directions to the
rst turn on the track at the top of the page.
4. Move in the direction of the rst turn. When
you reach the rst turn, directions to the next
turn are shown, and so on.
5. To exit, press MENU, and select Stop
Navigation.
To create a user waypoint on a saved track:
1. With a saved track shown on the map, use
the ROCKER to move the pointer to the place
on the track that you want to mark as a user
waypoint. If the pointer is placed on the map
where no map item is located, a prompt asks if
you want to create a waypoint.
2. Press and hold the ENTER key to open the
Mark Waypoint Page.
3. Customize the user waypoint, highlight OK,
and press ENTER to save it.
30 GPSMAP 60Cx Owner’s Manual
bAsIc oPerAtIon > usIng trAcKs