Filter
Top Products
Installing the Batteries
The GPSMAP 60Cx operates on two AA batteries
(not included), which are installed in the back of the
unit. You can use Alkaline or NiMH batteries. See
page 55 for information on setting the battery type.
To install the batteries:
1. Remove the battery cover
by turning the D-Ring 1/4
turn counter-clockwise and
pulling the cover loose.
2. Insert the batteries,
observing the proper
polarity. A polarity diagram
is molded into the battery
compartment.
3. Reinstall the battery cover
by aligning the back cover
with the unit and turning the
D-Ring 1/4 turn clockwise.
Remove the batteries from your GPSMAP 60Cx when
you do not expect to use the unit for several months.
Stored data is not lost when batteries are removed.
To install the Lanyard:
1. Place the loop of the lanyard through the slot
at the upper-left side on the back of the unit.
2 Route the strap through the loop, and pull tight.
Refer to page 9 for information on accessing the
microSD
™
data card in the battery compartment.
USE BY 2009
USE BY 2009
Battery
Compartment
USE BY 2009
USE BY 2009
Battery
Compartment
Lanyard
installation
2 GPSMAP 60Cx Owner’s Manual
gettIng stArted > InstAllIng the bAtterIes