Filter
Top Products
170
Using the CVA-1000
(sold separately)
English
Audio Processor Setting
Function
The SEA-8081 allows you to control audio
processor settings. Use the following
procedure to change audio processor
settings.
This function allows to playback an audio
source with setting values for the Treble and
Bass memorized by the remote control
owner.
Applicable to up to 4 remote controls.
1 Press TX/PANIC button to set the disarm
mode.
2 Enter the vehicle.
Turn the ignition switch to the ON position.
3 Turn on the power of the CVA-1000.
Select and play a music source on the CVA-
1000.
Press and release the EXT SELECT button.
The "Audio Cont." screen will appear on the
CVA-1000 for 5 seconds. Please note the
Audio Processor Setting function cannot be
used while the Audio Control function is
being utilized.
Notes:
• The above function cannot be operated
when the Audio Control function is
activated.
• The Treble and Bass values can be
memorized automatically by turning off the
ACC.
• If the audio source is changed, perform
the operations described under the steps
3 and 4 .
1
3
E
X
T
S
E
L
E
C
T
2
Security
MODE
AUDIO PROCESSOR
SET TO USER 1
SET TO USER 1
SET TO USER 2
SET TO USER 3
SET TO USER 4
AUDIO
CONT.
4
(SEA-8481)
ACC
OFF
ON
RUN
TX
PANIC
(SEA-8481)