Filter
Top Products
H
ELECTRICAL SYSTEM
H - 22
SERVICE
CONTROL REPLACEMENT
Individual replacement parts are available for the control panel. To replace switches
remove the two (2) screws from front of panel and pull forward, exposing wiring.
1 .To remove directional switch push firmly on the front toggle and remove switch from
back side of panel. Cut wires to the defective switch, and splice wires (with butt
connectors) to the new switch, being sure to match wire colors. Note: Install switch
with yellow wire on top for correct directional aiming.
2. To remove On/Off fuse switch disconnect w-1res to defective switch and pull
forward will gentle rocking motion from backside of panel easing switch out. Install
new switch and secure using clip retainer on backside of control panel. Reconnect
wiring terminals to switch.
BULB REPLACEMENT
Remove four (4) screws and retaining bezel. Pull bulb assembly forward and discon-
nect spade connectors from back of bulb. Reconnect spade terminals to new bulb.
Install bulb and fasten with bezel and four (4) screws.
PARTS LIST
Part No. Description
18753-0178 Bulb Kit
43990-0000 Directional Switch
18753-0180 On/Off Fuse Switch
64073-0020 Station Selector Switch
60030-0000 Control
45969-1000 12/24 Volt Converter
60023-1000 Upper Housing
60024-1000 Lower Housing
60027-1000 Bass
60035-1000 Bulb Retainer