A SERVICE OF

logo

Open as PDF
next previous
W
EBASTO
S
CHOLASTIC
S
ERIES
5INSTALLATION
5-7
5.7 Fuel System
5.7.1 General Description
The fuel is drawn from the vehicles fuel tank through a fuel standpipe. This standpipe can be utilized on vehicles with
a threaded port in the fuel tank for this purpose.
IMPORTANT! Keep the fuel standpipe 50 mm (2”) from bottom of the fuel tank.
5.7.2 Fuel Supply
Fig. 5-7: Fuel Standpipe Installation
The fuel standpipe and fuel line must be installed according to these instructions to ensure proper heater operation.
1. Cut or extend universal fuel standpipe to length, approx. 50 mm (2”) off fuel tank bottom. Slash cut standpipe
end on a 45° angle to help prevent clogging.
NOTE:
After fuel standpipe has been cut to length, remove all burrs from cut inlet end. Check valve directional indication
mark (arrow or symbol) must point in direction of fuel source (fuel tank).