A SERVICE OF

logo

8
Rev B
SATO SERVICE MANUAL
CX Series Printers
POWER INPUT
READY INDICATOR
ON-LINE/OFF LINE
BUTTON
FEED BUTTON
UNDERSIDE OF PRINTER
POWER
SUPPLY
AC OUTLET
1. Plug the output of the AC power supply provided with the printer
into the connector on the underside of the printer.
2. Plug the supply into an AC outlet having the correct voltage.
Important!
The required AC voltage is marked on the power supply.
Confirm that your AC voltage matches the power supply
requirements. Do not use any power supply other
then the one provided with the printer.
Note:
CX200 printers consume very little power when idle so are not equipped
with a power switch. Press the READY indicator/ON-OFF (a combined
control) to reset the printer and switch from OFF-Line to On-Line mode.
SECTION 1 - GENERAL INFORMATION
1-5 Controls, Indicators and Connections
Printer Power Connection