A SERVICE OF

logo

Open as PDF
next previous
45
Rev B
SATO SERVICE MANUAL
CX Series Printers
Motor removal:
1. Remove the printer chassis according to the instructions in Section 3-4.
2. Remove the two Phillips-head screws holding the PCA base board in
place.
3. Lift the PCA base board gently, then unplug the feed switch connector at
J13
4. Unplug the motor wiring at connector J10
5. Remove the Phillips-head screw holding the motor in place.
6. Turn the motor body until the motor flanges clear the printer chassis,
then remove the motor.
Motor installation:
Reverse the above steps to install the motor.
3-9 Motor Removal/Replacement
REFER TO THE ACCOMPANYING ILLUSTRATIONS
REMOVE PHILLIPS-
HEAD SCREW AND
LIFT THE MOTOR
UNPLUG THE
CONNECTOR
AT J10