A SERVICE OF

logo

26
Rev B
SATO SERVICE MANUAL
CX Series Printers
1-8 Basic Operations
Printing and Reading a Self-test Label
Firmware Revision
Serial Number
RS232 Setting
Current Printer Heat Setting
Total Number of Inches Printed
Print Speed
Current Calibration Setting
Print Mode (DT= Direct Thermal )
(TT= Thermal Transfer)
Label Forward/Backfeed
Protocol Codes
(Factory Use Only)
Expanded Memory Installed
Pitch Offset
Hex Dump Mode
Hex Dump Code
When sending data in normal operation and nothing prints, put the printer in the Hex
mode and try resending the data. The printer should print out the hex characters
corresponding to the data received. If nothing prints, check cabling and media. If you
get a hex dump, compare it to the command stream you are sending. If it is the same,
the command sent could be wrong. Refer to the Programming Guide for information
on programming the printer and the correct use of the printer commands.
EXAMPLE:
SELF TEST LABEL