3. PROGRAM ERROR
I - 63
Error No. Details Remedy
P122 NO AUTO C-OVR
An automatic corner override command
(G62) has been issued though it is not
included in the specifications.
• Check the specifications.
• Delete the G62 command from the program.
P126 ILL. CMD(H.A.)
An illegal command was issued during
the high-accuracy control mode.
• A G code group 13 command was
issued during the high-accuracy
control mode.
• Milling, cylindrical interpolation or pole
coordinate interpolation was
commanded during the high-accuracy
control mode.
• Reconsider the program.
P130 2nd AUX. ADDR
The 2nd miscellaneous function address
specified in the program does not match
that set by the parameter.
• Check and correct the 2nd miscellaneous
function address in the program.
P131 NO G96 SPEC
(No constant peripheral speed)
The constant peripheral speed command
(G96) was issued despite the fact that
such a command does not exist in the
specifications.
• Check the specifications.
• Change from the constant peripheral speed
command (G96) to the rotation speed
command (G97).
P132 SPINDLE S = 0
No spindle speed command has been
specified.
• Reconsider the program.
P133 G96 P-No. ERR
An invalid constant peripheral speed
control axis has been specified.
• Reconsider the parameter specified for the
constant peripheral speed control axis.
P140 NO T-POS OFST
The position compensation command
(G45 to G48) specifications are not
available.
• Check the specifications.
P141 PAT-ROT ERROR
Position compensation was commanded
during the figure rotation or coordinate
rotation command.
• Reconsider the program.
P142 T-OFFS G2 ERR
A position compensation invalid arc
command was commanded.
• Reconsider the program.
