5. BASE SPECIFICATIONS PARAMETERS
II - 32
(SETUP PARAM 1. 4/16)
# Items Details Setting range (unit)
1073 I_Absm Initial
absolute
value
Specify the absolute value/incremental value
mode for when the power is turned ON or reset.
0: Incremental value
command mode
1: Absolute value
command mode
1074 l_Sync Initial
synchronous
feed
Specify the feedrate specification mode for when
the power is turned ON or reset.
0: Asynchronous feed (feed per minute)
1: Synchronous feed (feed per rotation)
0: Asynchronous
feed
1: Synchronous feed
1075 I_G00 Initial G00 Specify the linear command mode for when the
power is turned ON or reset.
0: Linear interpolation (G00 command state)
1: Positioning (G01 command state)
0: Linear
interpolation
1: Positioning
1076 Abslnc
(For L
system
only)
ABS/INC
address
The absolute value/incremental commands can
be issued by using the absolute value address
and incremental value address for the same axis.
0: Absolute/incremental with G command
1: Absolute/incremental with address code
(The #1013 axname address will be the
absolute value command‚ and #1014 incax
address will be the incremental value
command)
0: Absolute/
incremental with G
command
1: Absolute/
incremental with
address code
1077 radius Incremental
command for
diameter
specification
axis
Specify if the diameter specification axis’ (#1019
dia is set to 1) incremental value command uses
the diameter value or radius value
0: Diameter value
1: Radius value
1078 Decpt2 Decimal point
type 2
Specify the unit of position commands that do not
have a decimal point.
0: The min. input command unit is used
(follows #1015 cunit)
1: 1mm (or 1inch) unit is used
(For the dwell time, 1s unit is used.)
0: The min. input
command unit is
used
1: 1mm (or 1inch)
unit is used
1079 F1digt Validate F1
digit
Specify whether to execute the F command with a
1-digit code command or with a direct numerical
command.
0: Direct numerical command (command
feedrate during feed per minute or rotation)
1: 1-digit code command (feedrate specified
with #1185 spd_F1 – #1189 F5)
0: Direct numerical
command
1: 1-digit code
command
1080 Dril_Z
(For D
system
only)
Specify boring
axis
Specify a fixed cycle hole drilling axis.
0: Use an axis vertical to the selected plane as
the hole drilling axis.
1: Use the Z axis as the hole drilling axis
regardless of the selected plane.
0/1
