5. BASE SPECIFICATIONS PARAMETERS
II - 69
# Items Details Setting range (unit)
1272
(PR)
ext08
(bit0)
Switch pocket
machining
operation
0: Conventional specifications
Pocket machining is selected with the H
designation.
The pull direction when pocket machining is
ON is the Z direction.
1: Extended specifications
If there is an X and Z axis in the first
movement block after the finished shape start
block is started, pocket machining will start.
The pull direction when pocket machining is
ON is the X direction.
0/1
ext08
(bit1)
M function
synchronous tap
cycle
Specify whether to enable the M function
synchronous tap cycle.
0: Invalid
1: Valid
0/1
ext08
(bit3)
Switch macro
call function
Select whether to shift the argument to the
subprogram if nests are overlapped when per block
call (G66.1) is commanded.
0: Shift argument even if nests are overlapped.
1: Do not shift arguments if nests differ.
(Conventional specifications)
0/1
ext08
(bit4)
Tap cycle
selection
Select the tap cycle.
0: Pecking tap cycle
1: Deep hole tap cycle
0/1
ext08
(bit5)
Deep hole tap
cycle override
selection
Select whether to validate override on the pulling
operation during synchronized tapping with the
deep hole tap cycle.
0: Invalid
1: Valid
0/1
ext08
(bit6)
Switch corner
chamfering/
corner R
command format
The corner chamfering/corner R command format is
extended.
0: Command format I (conventional format)
Issue a command with comma (,C and ,R).
1: Command format II
In addition to command format I, commands
can be issued with an address that does not
have a comma.
Corner chamfering: I/K or C, corner R: R
0/1
ext08
(bit7)
Return position
after macro
interrupt in fixed
cycle selection
Select the destination to return to after a macro
interrupt in the fixed cycle.
0: Return to block in fixed cycle.
1: Return to block after fixed cycle.
0/1
