Limit Switch Adjustments 23
Doc 01-G0610
Rev A
12 Fine tune both the open and close limit switch settings by using
the OPEN, CLOSE and STOP buttons to move the gate and by
rotating the limit collars slightly to allow more or less gate
travel.
Rotating cam away from the
limit switch increases gate
travel. Rotating cam
towards the switch allows
less gate travel.
CAUTION
Always turn off power before placing hands or tools in
operator or near drive shaft and control arm.
The close limit switch should stop the gate at a point where the
elbow of the control arm just passes the position when the (2)
arm pieces are in a straight line (180 degrees).
With the control arm past the 180-degree position, the gate is
effectively locked against any attempts to push it open from the
outside.
Refer to Figure 10. The
extra holes in the control
arm extension may be used
to aid in attaining the final
desired close position of the
gate and arm.
