Introduction
2
Windows System Requirements
To use your printer and its software with a PC, your system
should have:
◗ An IBM
®
compatible PC with at least a 486 DX2/66 MHz
or faster processor (Pentium
®
100 or equivalent
recommended)
◗ Windows
3.1x, Windows 95 or later, or Windows NT 4.0
◗ At least 16MB of RAM (20MB recommended)
◗ At least 50MB of free hard disk space for storing images
(100MB recommended)
◗ VGA, Super VGA, or better display adapter and monitor
◗ Double-speed CD-ROM drive (quad-speed or faster
recommended)
◗ A shielded, twisted-pair parallel printer cable (6 to 10 feet
long) to connect your computer to the printer; the cable
must have a D-SUB, 25-pin, male connector for your
computer and a 36-pin, Centronics
®
compatible connector
for the printer.
Macintosh System Requirements
To use your printer and its software with a Macintosh, your
system should have:
◗ Any Macintosh or Power Macintosh model except early
models such as the Macintosh Classic, Macintosh +,
Macintosh 512, or PowerBook
™
100
◗ System 7.1 or later (7.5 or later recommended)
◗ At least 16MB of built-in RAM (20MB is recommended)
◗ At least 50MB of free hard disk space for storing images
(100MB recommended)
◗ 13-inch RGB or better display
Note:
If you don’t have a
CD-ROM drive, you can
get the printer driver
software on diskettes
or download it through
your modem. See your
Getting Started
guide
for details.
Intro.fm5 Page 2 Thursday, March 19, 1998 4:31 PM
