569
Practical hints
Flat tire
5
Allow the electric air pump to run un-
til tire sealant bottle
8 is completely
empty.
̈ Press 0 on electric air pump
switch
1 after about 15 seconds.
̈ Unscrew angle bracket c from tire
valve
b and remove it.
̈ Screw in the valve core with the
valve tool again and take out the
valve tool through the opening.
̈ Press angle bracket 2
(
୴ page 559) on hose 3 of the elec-
tric air pump to the stop on tire
valve
b and clamp it into place.
̈ Press switch 1 on the electric air
pump to
I and pump up the tire until
the recommended tire pressure
(
୴ page 361) is achieved.
̈ Then press 0 on electric air pump
switch
1.
The electric air pump is switched off.
̈ Screw the valve cap onto tire
valve
b.
̈ After filling with tire sealant
(
୴ page 570).
!CAUTION
Do not run the electric air pump for
more than 20 minutes without a
break, otherwise it may overheat.
The air pump can be used again once
it has cooled down.
i
The tire sealant is water soluble. If
tire sealant escapes, you can wash it
away with water.
nf_BA.book Page 569 Friday, January 25, 2008 3:53 PM
