561
Practical hints
Flat tire
5
Single tire
9
Hook
a Knob
b Lever
c Valve core extractor
d Tire valve
̈ Pull knob a out of valve core extrac-
tor
c as far as the stop.
̈ Unscrew and remove the valve cap
from tire valve
d on the flat tire.
̈ Hook the tire sealant bottle into the
upper vent hole in the wheel using
hook
9.
̈ Keep lever b pressed, connect
valve core extractor
c firmly to tire
valve
d and release lever b.
̈ Press knob a into the valve core of
tire valve
d, turning it gently as you
do so, until the shaft of valve core
extractor
c engages.
̈ Turn knob a counterclockwise until
the valve core is unscrewed.
̈ Pull knob a out of valve core extrac-
tor
c as far as the stop.
̈ This pulls the valve core into the
valve core extractor and seals it
against the valve core extractor stop.
̈ Make sure that the pressure release
screw on pressure gauge
5 is
closed.
̈ Connect connector 6 to the 12 V
socket (12 V, 25 A, 300 watts) on
the center console (
୴ page 297).
nf_BA.book Page 561 Friday, January 25, 2008 3:53 PM
