117
Dialogic
®
DSI SS7MD Programmer’s Manual Issue 3
Chapter 7: Configuration Command Reference
This chapter describes the commands and parameters used in the config.txt protocol configuration file. These
commands are used by the s7_mgt protocol configuration utility to perform one time configuration of the
protocol stack at startup.
The commands are logically grouped in the following categories:
• Physical Interface Configuration Commands
• Monitor Configuration Commands
• MTP Configuration Commands
• ATM Configuration Commands
• ISUP Configuration Commands
• TUP Configuration Commands
• SCCP Configuration Commands
• DTC Configuration Commands
• TCAP Configuration Commands
• MAP Configuration Commands
• INAP Configuration Commands
• IS41 Configuration Commands
