29
CHAPTER 4: Installation and Initial Configuration
6. Configure the channels in your system. (Check the [Scroll Lock] LED on one
of your user-station keyboards. If it’s blinking, the Summit is ready to accept
hotkey commands from that user station. Hotkey commands can be used with
the OSUI to login, select computers, or administer the system.)
a. At the Login Menu, type admin in the User Name field and press [Enter].
In the Password field, type the default password blackbox (all lowercase)
and press [Enter].
b. The monitor should display the OSUI’s Selection Menu, indicating that the
USM is correctly installed. After you’ve finished installing and configuring
your cascaded system, this menu might resemble Figure 4-8.
Figure 4-8. A Selection Menu (shown after a hypothetical cascaded system
configuration is finished).
c. Press [F5] to bring up the Administration Menu, shown in Figure 4-5 in
Section 4.2. Use the up- and down-arrow keys to move the highlight to the
Channel Configuration entry and press [Enter] to select it.
d. The Channel Configuration menu should appear. Use the up- and down-
arrow keys and [PageUp] and [PageDown] keys to approach channels that
subsidiary Base Units are connected to. These will be shown in white with
their default device names in the Name column and their types in the
Device column: “S242” for a 2 x 42 Base Unit (KV1500A), “S442” for a 4 x
42 Base Unit (KV1501A), “S832” for an 8 x 32 Base Unit (KV1502A), or
“S1664” for a 16 x 64 Base Unit (KV1503A). After you’ve finished installing
and configuring your cascaded system, this menu might resemble Figure 4-9.
Selection Menu
Main_16x64 Page 1/8
No Ch.ID Name Scn
-- -------- ------------ ---
1 01 03
2 02 NT40-Mail 03
3 03 Wins95_Bob 03
4 04 Wins98_Jack 03
5 05 Matrls_8x32 --
6 06 NT40-Fax 03
7 07 Mrktng_8x32 --
8 08 PubSrv_8x32 --
-- -------- ------------ ---
ScrlLock | Scan | Skip NCSL
3 03 Wins95_Bob 03
Page FKey Ent Esc
