23
CHAPTER 4: Installation and Initial Configuration
Figure 4-2. Rear panels of a ServSwitch Summit USM (KV1510A, top) and
8 x 32 Base Unit (KV1502A, bottom) (not shown at the same scale).
3. Initially configure the USM.
a. The Login Menu (shown in Figure 4-3) should be displayed on the USM’s
attached monitor. If the [Scroll Lock] LED on the USM’s attached
keyboard is blinking, the Summit is ready to accept hotkey commands,
which can be used with the OSUI to login, select computers, or administer
the system.
If the monitor instead displays a “.....No connection to Summit.....”
message, the USM isn’t properly connected to the Base Unit. Check for
loose connections and make sure you’re using good, intact CAT5 cables.
(See Appendix F for UTP-cabling information.)
Figure 4-3. The Login Menu for a KV1502A.
b. Type admin in the User Name field and press [Enter]. In the Password
field, type the default password blackbox (all lowercase) and press
[Enter].
c. The monitor should display the OSUI’s Selection Menu as shown in
Figure 4-4, indicating that the USM is correctly installed.
Please Login ServSwitch Summit
Device ID: Summit 8x32
User Port: 1
User Name:
Password:
Enter Name and Password
