Command Set
4-
36
ADAM 4000 Series User’s Manual
ADAM-4080 Command Table
Command Syntax
Command Name Command Description Page
No.
%AANNTTCCFF Configuration Sets the address, input mode,
baud rate, checksum status and/or
frequency gate time for a specified
counter/ frequency module
7-28
$AA2 Configuration Status Returns configuration parameters
from the specified
counter/frequenc
module
7-30
$AAF Read Firmware
Version
Return firmware version code from
the specified counter/frequency
module
7-31
$AAM Read Module Name Return the module name from the
specified counter/frequency
module
7-32
$AABS Set Input Signal
Mode
Sets the input signal mode of the
specified counter/frequency
module to either non-isolated or
photo-isolated input si
nals
7-33
$AAB Read Input Signal
Mode
Read the input signal mode of the
specified counter/frequency
module.
7-34
#AAN Read Counter or
Frequency Value
Returns the value of counter 0 or
counter 1 from a specified counter/
frequenc
module in hex format
7-35
(Continued on following page)
