Filter
Top Products
8-43
8
5. Install the headlight bulb holder by aligning the
projections with the holes in the headlight unit,
pushing it inward, and turning it clockwise until
it stops.
6. Install the headlight bulb holder cover at the
rear of the headlight.
NOTICE
ECB00670
Make sure the headlight bulb holder cover is
securely fitted over the bulb holder and seated
properly.
7. Adjust the headlight beam if necessary.
EBU25560
Adjusting a headlight beam
NOTICE
ECB00690
It is advisable to have a Yamaha dealer make
this adjustment.
To raise a headlight beam, turn the adjusting bolt
in direction (a).
To lower a headlight beam, turn the adjusting bolt
in direction (b).
EBU25600
Replacing the tail/brake light bulb
If the tail/brake light bulb burns out, replace it as
follows.
1. Headlight beam adjusting bolt
U5YT16E0.book Page 43 Friday, March 14, 2008 9:56 AM