Filter
Top Products
PERIODIC MAINTENANCE AND ADJUSTMENT
7-37
7
5. Remove the auxiliary light bulb
socket (together with the bulb) by
turning the socket counterclock-
wise.
6. Remove the burnt-out bulb by pull-
ing it out.
7. Insert a new bulb into the socket.
8. Install the socket (together with the
bulb) by pushing it in and turning it
clockwise.
9. Install the headlight unit by install-
ing the bolts, and then tightening
them to the specified torque.
10. Install the headlight unit cover by
installing the bolts.
11. Install the panel by installing the
quick fasteners.
12. Install the windshield by installing
the screws in the lower holes, and
then tightening them to the speci-
fied torque. WARNING! A loose
windshield could cause an acci-
dent. Be sure to tighten the
screws to the specified torque.
[EWA15510]
1. Auxiliary light bulb socket
1. Auxiliary light bulb
1
1
Tightening torque:
Headlight unit bolt:
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
Tightening torque:
Windshield screw:
0.5 Nm (0.05 m·kgf, 0.36 ft·lbf)
1. Lower hole
1
1
U23P11E0.book Page 37 Tuesday, August 7, 2012 4:57 PM