Filter
Top Products
INSTRUMENT AND CONTROL FUNCTIONS
4-24
4
3. Install the rider seat height position
adjuster so that the match mark is
aligned with the “H” mark as
shown.
4. Insert the projection on the rear of
the rider seat into seat holder B as
shown.
TIP
Make sure that the rider seat is properly
secured before riding.
EAU49882
Windshield
If the original windshield is removed
and then reinstalled, be sure to install
the windshield screws in the lower
holes and tighten the screws to the
specified torque. WARNING! A loose
windshield could cause an accident.
Be sure to tighten the screws to the
specified torque.
[EWA15510]
1. Rider seat height position adjuster
1. Rider seat height position adjuster
2. “H” mark
3. Match mark
1
2
3
1
1. Projection
2. Seat holder B (for high position)
1
2
Tightening torque:
Windshield screw:
0.5 Nm (0.05 m·kgf, 0.36 ft·lbf)
1. Lower hole
1
1
U23P11E0.book Page 24 Tuesday, August 7, 2012 4:57 PM