Filter
Top Products
8 - 36
CHAS
STEERING SYSTEM
REMOVING THE STEERING KNUCKLES
1.Remove:
●
Steering knuckle 1
N
OTE:
Use a general puller to separate the ball joints
2 from the steering knuckle 1 or the front
lower arm 3.
CHECKING THE TIE RODS
1.Check:
●
Tie rod free play and movement
Free play → Replace the tie rod end.
Turns roughly → Replace the tie rod end.
2.Check:
●
Tie rods
●
Bends/damage → Replace.
CHECKING THE STEERING KNUCKLES
1.Check:
●
Steering knuckles
Damage/pitting → Replace.
2.Check:
●
Ball joints
Damage/pitting → Replace the ball joint.
Free play → Replace the ball joint.
Turns roughly → Replace the ball joint.
*****************************************************
Replacement steps:
●
Clean the outside of the steering knuckle.
●
Remove the steering knuckle oil seal.
●
Remove the circlip 1 and rubber boot 2.
Use the ball joint remover and installer set.