Filter
Top Products
4 - 79
ENG
MIDDLE GEAR
2.Remove:
●
Nut 1
●
Washer
●
Universal joint yoke
N
OTE:
Use the universal joint holder 2 to hold the
universal joint yoke.
3.Remove:
●
Bearing housing assembly 1
*****************************************************
Removal steps:
●
Clean the outside of the middle driven shaft.
●
Place the middle driven shaft onto a
hydraulic press.
CAUTION:
●
Never directly press the shaft end with a
hydraulic press, this will result in damage
to the shaft thread.
●
Install the suitable socket
2
on the shaft
end to protect the thread from damage.
●
Press the shaft end and remove the bearing
housing.
*****************************************************
4.Remove:
●
Bearing retainer
●
Bearings
*****************************************************
Removal steps:
●
Attach the folded rag 1.
●
Secure the bearing housing edge in the vise.
●
Attach the bearing retainer wrench 2.
CAUTION:
The middle driven shaft bearing retainer
has left-handed threads. To loosen the
bearing retainer, turn it clockwise.
●
Remove the bearing retainer and bearings.
*****************************************************
Universal joint holder:
P/N. YM-04062, 90890-04062
Bearing retainer wrench:
P/N. YM-04128, 90890-04128