Filter
Top Products
4 - 41
ENG
RECOIL STARTER AND A.C. MAGNETO
2.Install:
●
Woodruff key
●
Rotor
N
OTE:
●
Before installing the rotor, clean the outside
of the crankshaft and the inside of the rotor.
●
After installing the rotor, check that the rotor
rotates smoothly. If not, reinstall the key and
rotor.
3.Install:
●
Dowel pins
●
Gasket
●
Crankcase cover (left)
N
OTE:
●
When installing the crankcase cover (left),
use a long rod to hold the rotor in position
from the outside. This will make assembly
easier. Be careful not to damage the oil seal.
●
Tighten the bolts in stages, using a
crisscross pattern.
New
T
R
.
.
10 Nm (1.0 m • kg, 7.2 ft • lb)
4.Install:
●
Starter pulley 1
N
OTE:
Use a rotor holding tool 2 to hold the starter
pulley.
N
OTE:
Before installing the starter pulley, do not
forget to install the O-ring.
Rotor holding tool:
P/N. YU-01235, 90890-01235
T
R
.
.
50 Nm (5.0 m • kg, 36 ft • lb)