Filter
Top Products
7 - 23
DRIV
REAR AXLE/FINAL DRIVE GEAR AND DRIVE SHAFT
●
Remove the ring gear assembly.
●
Measure the thrust clearance. Calculate the
width of the flattened Plastigauge
®
1.
●
If out of specification, select the correct
washer.
Ring gear thrust clearance:
0.1 ~ 0.2 mm (0.004 ~ 0.008 in)
Thrust washer selection steps:
●
Select a suitable thrust washer using the
following chart.
●
Repeat the measurement steps until the ring
gear thrust clearance is within the specified
limits.
*****************************************************
Thrust washer
Thickness (mm)
1.0 1.1 1.2
1.3 1.35 1.4
1.45 1.5 1.55
1.6 1.7 1.8
1.9 2.0 2.1
Ring gear stopper shim selection
1.Measure:
●
Ring gear stopper clearance “D”
Use a feeler gauge 1.
Out of specification → Adjust.
2
Ring gear
3
Ring gear stopper
Ring gear stopper clearance “D”:
0.30 ~ 0.60 mm (0.012 ~ 0.024 in)