Filter
Top Products
8-14
5. Remove the coolant reservoir cap.
6. Disconnect the hose on the coolant res-
ervoir side, and then drain the coolant
from the coolant reservoir.
1. Coolant reservoir cap 2. Hose
7. After draining the coolant, thoroughly
flush the cooling system with clean tap
water.
8. Replace the coolant drain bolt washer if it
is damaged, and then tighten the coolant
drain bolt to the specified torque.
9. Install the coolant reservoir hose.
10. Pour the recommended coolant into the
radiator until it is full.
11. Fill the coolant reservoir with coolant up
to the maximum level.
Tightening torque:
Coolant drain bolt:
10 Nm (1.0 m·kgf, 7 ft·lbf)
Recommended antifreeze:
High quality ethylene glycol antifreeze
containing corrosion inhibitors for alumi-
num engines.
Antifreeze and water mixing ratio:
1:1
Total amount:
1.3 L (1.14 Imp qt, 1.37 US qt)
Coolant reservoir capacity:
0.29 L (0.26 Imp qt, 0.31 US qt)
U5LP12.book Page 14 Friday, April 26, 2002 2:47 PM