Filter
Top Products
8-7
6. Clean the oil strainer and oil filter with
solvent.
7. Inspect the O-ring and replace if
damaged.
8. Reinstall the oil filter, O-ring, oil filter
cover.
9. Replace the oil strainer, compression
spring, O-ring and drain plug. Then,
tighten the drain plug and oil filter cov-
er bolts to the specified torques.
CAUTION:
Before reinstalling the drain plug, be sure
to install the O-ring, compression spring
and oil strainer.
10. Fill the engine with oil and install the
dipstick.
CAUTION:
Be sure no foreign material enters the
crankcase.
11. Warm up the engine for several min-
utes at idle speed. Check for oil leak-
age while warming up.
Tightening torque:
Drain plug (engine):
43 Nm (4,3 m·kg, 31 ft·lb)
Filter cover bolt:
10 Nm (1.0 m·kg, 7.2 ft·lb)
Recommended oil:
See page 5-7.
Oil quantity:
Periodic oil change:
1.5 L (1.3 Imp qt, 1.6 US qt)
With oil filter replacement:
1.6 L (1.4 Imp qt, 1.7 US qt)
Total amount:
1.8 L (1.6 Imp qt, 1.9 US qt)