Filter
Top Products
8
Part 5 Quick use guide
Package :WBT-100(blue tooth GPS logger)+USB cable+ sticker ＋car cigarette lighter
power adaptor , installation Disk, Quick use guide
WBT-100 Operation
Temporarily press power button to turn it on. The blue tooth and GPS status led will
glow to confirm it is in GPS mode
GPS Led glows red to show GPS acquisition is done ( 1 Hz). But if this led is solid on,
the GPS acquisition fails.
Temporarily press on power button. Blue tooth will turn off after blue tooth led goes off.
Another press on power button can turn blue tooth on after its LED glows again.
Temporarily press on mode button each time can switch between compass mode
(LED glows green) and GPS mode (LED glows red)
It is strongly recommended to have WBT-100 calibrated in any
environment ahead of use. Press and hold the mode button to enter
into calibration status which is displayed by orange LED. Press shortly
again the same button to get out of calibration status and remain in
compass mode (LED glows green). But if calibration fails, it will jump
into GPS mode (LED glows red in this situation)
After power on, press and hold power button to turn the power off.
If red LED starts to blink, the power is low and needs recharging. Led stays solid while
charging .It glows green after it is fully charged.
When the USB is used as interface:-
USB driver must be installed first
After connection to USB port of computer, place the WBT-100 suitable
area where it can best receive GPS signal for acquisitioning
Power it(or switch its power on)
WBT-100 will start acquisition
When the blue tooth is used as interface:-
Ahead of blue tooth connection, make sure the target device to pair
can support blue tooth SPP master
After pairing with WBT 100, place it at suitable area where it can best
receive GPS signal for acquisitioning
Activate the software of paired device. WTB 100 starts to provide GPS