Filter
Top Products
49
Oil change. MS25
Remove the dipstick. Suck up oil using an oil pump
through the hole for the dipstick. Measure out the
correct amount of oil and fill up through the hole for
the oil dipstick. For oil quality and capacity: See the
chapter ”Technical Data”.
IMPORTANT! Never overfill reverse gear. The oil
level should always lie at the recommended
level.
1
2
3
4
5
Maintenance: S drive and reverse gear
Oil change and filter cleaning. HS25
1. Clean around the cover (2) so that there is no risk
of the dirt falling into the filter housing.
2. Undo the screws (1). Remove the cover (2) and
gasket (3).
3. Carefully remove the filter (4). Clean the filter in
kerosene (leave the gasket (5) in place). Clean the
filter housing.
4. Suck up oil using an oil pump through the hole for
the dipstick.
5. Measure out the correct amount of oil and fill up
through the hole for the oil dipstick or filter housing.
For oil quality and capacity: See the chapter
”Technical Data”.
IMPORTANT! Never overfill reverse gear.
6. Reinstall the filter (4) with gasket (5) in the filter
housing. Check that the filter bottoms correctly.
IMPORTANT! If the filter does not sit flat
there is a risk of breaking it when the cover
(2) is installed.
7. Center the gasket (3) above the filter. Install the
cover.
8. Move the control lever to the neutral position. Start
engine and run at 1500 rpm for a few minutes so
the reverse gear oil cooler is filled with oil.
9. Stop engine and check oil level. Top up if required.
7742957 - Downloaded from www.volvopenta.com 22/09/2008 11:33:23