Filter
Top Products
41
Fuel pre-filter. Draining and replacing
filter insert
Draining
The fuel pre-filter is an optional extra.
Position a container under the fuel filter. Drain off
water and contaminants using the cock/plug at the
bottom of the filter bowl.
IMPORTANT! Wait a few hours after the engine
has been turned off before draining the filter.
Replacing filter insert
Close fuel cock at the fuel tank. Position a container
under the fuel filter.
Remove the filter bowl by undoing screw (1). Empty
and clean the filter bowl. Replace insert and reinstall
the bowl. Open fuel cock. Vent fuel system. Deposit
the old filter insert at a properly designated dis-
posal site.
Start the engine and check for leaks.
WARNING! Approaching or working on a running
engine is dangerous. Watch out for rotating
components and hot surfaces.
Fuel filter. Changing
Clean the filter mounting. To avoid fuel spills put a
plastic bag over the filter before it is unscrewed.
Unscrew the filter. Moisten the filter rubber gasket
with a little oil. Screw on the new filter by hand until it
is in contact with the mating surface. And then a
further half turn but no more! Vent fuel system.
Deposit the old filter at a properly designated
disposal site.
Start the engine and check for leaks.
WARNING! Approaching or working on a running
engine is dangerous. Watch out for rotating
components and hot surfaces.
1
Maintenance: Fuel system
7742957 - Downloaded from www.volvopenta.com 22/09/2008 11:33:23