Viper 160XVL Automobile Alarm User Manual


 
14
©
2006 Directed Electronics—all rights reserved
When you are ready to drive the vehicle:
1. Insert the ignition key and
turn it to the ON (not the
START) position.
2. Press the brake pedal.
NOTE: If the brake pedal is pressed before the key is in the ON position,
the engine will shut down.
While the vehicle is running during remote start operation, the
system will monitor the vehicle and will automatically shut down the
engine if the system receives any of the following shut-down inputs:
The brake pedal is pressed.
The hood is opened.
The shutdown toggle switch is put into the OFF position.
The pre-programmed run time (12, 24, or 60 minutes) has elapsed.
Transmitter button is pressed twice in 3 seconds to start
the vehicle.
To turn the rear defogger output OFF:
1. Simultaneously press & release the ++buttons
on the remote control.
2. The lights will flash 2 times.
3. The rear defogger output will no longer activate when the
vehicle is remote started.
NOTE: If the remote start is on the parking lights will turn off then flash
2-times before returning to their normal output and the defogger out-
put, if active, will cease.
Rear Defogger