Filter
Top Products
36
©
2006
Directed Electronics
Shock Sensor Adjustment
NNoottee::
This procedure only adjusts the on-board Zone 2 shock sensor.
Enter Shock Sensor Adjustment Mode
1. Press and hold and buttons for 4-seconds.
2. The system will emit 1 long chirp to indicate entry into shock adjustment mode.
3. The LED will illuminate continuously for the duration of shock adjustment mode.
NNoottee::
When the shock sensor adjustment mode is entered, all other timers and operations are bypassed
until adjustment mode is exited.
Adjusting the Shock Sensor Setting
NNoottee::
When adjusting the shock sensor, ensure that the vehicle’s doors are closed.
1.
IInnccrreeaassee SSeennssiittiivviittyy
—Press and release the button to increase shock sensor sensitivity by one
step. The siren will chirp 2-times for each step increased in adjustment. When the shock sensor
adjustment reaches maximum sensitivity the siren will emit 2 short chirps and then 1 long chirp.
2.
DDeeccrreeaassee SSeennssiittiivviittyy
—Press and release the button to decrease shock sensor sensitivity by
one step. The siren will chirp 1-time for each step decreased in adjustment. When the shock sensor
adjustment reaches minimum sensitivity (sensor is Off) the siren will emit 1 short and then 1 long
chirp.
IMPORTANT! The system must be disarmed, and doors and other protected entries
(zones 1 and 6) must be closed, and ignition (zone 5) must be off.