Uniden GNS8435 GPS Receiver User Manual


 
17
4.3.1 GPS data displayed
The virtual sky on the left represents the currently visible part of the sky above you,
with your position as the centre. The satellites are shown at their current positions.
The GPS receives data from both the green and grey satellites. Signals from the grey
satellites are only received, while green ones are used by the GPS to calculate your
current location. On the right you can see the satellite signal strength bars. Dark bars
are for the grey and orange bars are for the green satellites. To identify satellites use
their numbers also shown in the virtual sky. The more satellites your GPS tracks (the
green ones), the better your calculated position will be.
Additional pieces of information on this screen are: current position in latitude/
longitude format, elevation, speed, date, time and calculated accuracy.
Note: Accuracy can be affected by several factors the GPS cannot take into account.
Use this accuracy information only as estimation.
There are two icons on the left to show the status of the GPS connection and the
quality of reception.
4.3.2 GPS connection indicator
In the middle to the left there is a lamp similar to the ones used for switches. This one
has more colours and represents more values:
dark lamp means there is no communication on the selected port,
red lamp means connection to any GPS receiver has not been established
yet, so you need to set it up by using the Detect or Cong. buttons,
a slowly blinking yellow lamp means that there is no connection to the GPS
receiver, but Uniden Navigation is trying to connect,
a fast blinking green lamp means that there is communication with the GPS
and data is being received,
other colours may not appear with a built-in GPS. Should any of
these appear, this means a faulty operation of your device.