Filter
Top Products
16 ‘05 - ‘06 Tacoma (W/ O.E. Hitch) - 3” Kit 5613
f. At rear bed mount, install kit bolt (M12-1.25 x
180mm) and factory captive washer. DO NOT
TIGHTEN.
g. Repeat previous steps on driver side of bed.
h. Set bed-to-cab spacing according to previous
measurement.
i. Remove each kit bolt, one at a time, and apply a
few drops of kit Loctite® to threads. Install kit
bolt with factory captive washer.
Rear of Vehicle
1. Rear bumper
WARNING
The following procedure is intended only to enhance
the appearance of the vehicle. The rear bumper will no
longer be rated for towing of any kind. Towing with the
rear bumper after it has been lifted can result in death,
serious personal injury, or damage to the vehicle. Tow-
ing after the bumper has been lifted should be accom-
plished using a rated Class III receiver type hitch.
Install Kit Bolt
At This Mount
Kit Bolt
(M12-1.25 x 180mm)
a. Mark and cut driver and passenger O.E. trailer
hitch brackets along white lines as shown below.
Mark
& Cut
Here
BEFORE
Mark
& Cut
Here
BEFORE
AFTER