Filter
Top Products
ME(H4DOTC)-50
MECHANICAL
Engine Assembly
(2) Tighten other bolts while rotating the engine
by using ST.
CAUTION:
Be careful not to drop bolts into the torque con-
verter clutch housing.
ST 499977300 CRANKSHAFT PULLEY
WRENCH
Tightening torque:
25 N·m (2.5 kgf-m, 18.1 ft-lb)
(3) Clog the service hole with plug.
11) Install the fuel filter and bracket.
12) Install the power steering pump on bracket.
(1) Install the power steering tank on bracket.
(2) Install the power steering pump.
Tightening torque:
20.1 N·m (2.05 kgf-m, 14.8 ft-lb)
(3) Install the power steering pipe bracket on in-
take manifold RH.
(4) Connect the power steering switch connec-
tor.
(5) Install the front side V-belt, and adjust it.
<Ref. to ME(H4DOTC)-54, FRONT SIDE BELT,
INSTALLATION, V-belt.>
13) Lift-up the vehicle.
14) Tighten the nuts which hold the lower side of
transmission to engine.
ME-00044
ME-00046
ME-00038
ME-00037
ME-00036
ME-00035