Filter
Top Products
ME(H4DOTC)-48
MECHANICAL
Engine Assembly
(3) Remove the bolts which hold the right upper
side of transmission to engine.
28) Remove the engine from vehicle.
(1) Slightly raise the engine.
(2) Raise the transmission with garage jack.
(3) Move the engine horizontally until the main-
shaft is withdrawn from clutch cover.
(4) Slowly move the engine away from engine
compartment.
NOTE:
Be careful not to damage adjacent parts or body
panels with crank pulley, oil pressure gauge, etc.
29) Remove the front cushion rubbers.
B: INSTALLATION
1) Install the clutch release fork and bearing onto
transmission. (MT model)
(1) Remove the release bearing from clutch
cover with flat type screw driver.
(2) Install the release bearing on transmission.
(3) Install the release fork into release bearing
tab.
(4) Apply grease to the specified points.
• Spline: FX2200
• Shaft: SUNLIGHT 2
(5) Insert the release fork shaft into release
fork.
ME-00050
ME-00051
(A) Release fork
(B) Release bearing
(A) Spline (FX2200)
(B) Shaft (SUNLIGHT 2)
ME-00052
(A)
(B)
ME-00053
(A)
(B)